Dell PowerEdge R810 - Manual (Page 42)

42 About Your System
Alert! System
fatal error
during previous
boot.
An error caused the system to
reboot. Check other system
messages for additional
information for possible
causes.
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
System is in manufacturing
mode. Reboot to take the system
out of manufacturing mode.
BIOS Update
Attempt Failed!
Remote BIOS update
attempt failed. Retry the BIOS update. If
the problem persists, see
"Getting Help" on page 195.
Caution!
NVRAM_CLR jumper
is installed on
system board
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared. Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5). See
Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 59.
CPU set to
minimum
frequency.
The processor speed may be
intentionally set lower for
power conservation. If not an intentional setting,
check any other system
messages for possible causes.
Message Causes Corrective Actions
book.book Page 42 Thursday, February 18, 2010 2:06 PM