Dell PowerEdge R810 - Manual (Page 121)

Installing System Components 121
Installing Expansion-Card Riser 1
1 Align the expansion-card riser with the slot on the riser guide and the riser
guide pin on the system board. See Figure 3-17.
2 Lower the expansion-card riser into place until the expansion-card riser
connector is fully seated.
3 If applicable, reinstall the storage controller card. See "Installing the
Integrated Storage Controller Card" on page 128.
4 If applicable, reinstall the expansion card(s). See "Installing an Expansion
Card" on page 116.
5 Close the system. See "Closing the System" on page 85.
6 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Removing Expansion-Card Riser 2
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 84.
3 If installed, remove the expansion card from the expansion-card slot. See
"Removing an Expansion Card" on page 118.
4 To remove the expansion-card riser, lift the expansion-card riser from the
riser 2 connector on the system board. See Figure 3-17.
book.book Page 121 Thursday, February 18, 2010 2:06 PM