Dell XPS 420 (Late 2007) - Manual (Page 141)

Removing and Installing Parts
141
5 Disconnect the USB cable on the back of the Media Card Reader.
Disconnect the other end of the cable from the USB connector on the
system board (see "System Board Components" on page 103). Remove the
cable from any clips and lift out of the computer.
6 Pull the sliding plate towards the bottom of the system and hold; then,
slide the drive out through the front of the computer.
7 Replace the drive panel insert (see "Replacing the Drive-Panel Insert" on
page 126).
8 Replace the drive panel (see "Replacing the Drive Panel" on page 127).
9 Replace the computer cover (see "Replacing the Computer Cover" on
page 172).
10 Turn on the system and enter system setup (see "System Setup" on
page 178). Set the USB for FlexBay value to OFF.
1 sliding plate 2 sliding plate lever 3 Media Card Reader (not
present on all computers)
3
1
2
book.book Page 141 Tuesday, November 27, 2007 10:29 AM