Dell XPS 420 (Late 2007) - Manual (Page 108)

108
Removing and Installing Parts
6 Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts
at each end of the module.
7 Replace the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack
and then plug it into the computer.
8 Connect your computer and devices to electrical outlets, and then turn
them on.
9 Right-click the My Computer icon, then click Properties.
10 Click the General tab.
11 To verify that the memory is installed correctly, check the amount of
memory (RAM) listed.
Removing Memory
CAUTION:
Before you perform any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer’s electronic
components. You can do so by touching an unpainted metal surface on the
computer.
1 Follow the procedures in "Before You Begin" on page 99.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 101).
book.book Page 108 Tuesday, November 27, 2007 10:29 AM