Dell PowerEdge 500SC - Manual (Page 28)

Removing and Replacing the Bezel
The front bezel has status and attention indicators. You must remove the system cover in order to remove the bezel.
Removing the Bezel
1. Remove the system cover (see " Removing the System Cover and Support Beam ").
2. Press the three tabs along the side of the bezel (see Figure 5 -3 ).
3. Swing the bezel away from the system, disengage the hooks, and carefully pull the bezel away from the system.
Figure 5-3. Removing and Replacing the Bezel
Replacing the Bezel
Insert the bezel hooks into the system slots, and snap the bezel back onto the system (see Figure 5 -3 ).
Checking the Equipment
This section provides troubleshooting procedures for equipment that connects directly to the I/O panel of the system, such as the monitor, keyboard, or
mouse. Before you perform any of the procedures, see "
Checking Connections and Switches " in "Indicators, Messages, and Codes."
Troubleshooting the Video Subsystem
Problem
l Monitor
l Monitor interface cable
l Video memory
l Video logic
Action
1. Check the system and power connections to the monitor.
2. Run the video tests in the system diagnostics.
If the tests run successfully, the problem is not related to video hardware. Go to " Finding Software Solutions ."
If the tests did not run successfully see " Getting Help " for instructions on obtaining technical assistance.
Troubleshooting the Keyboard
Problem
l A system error message indicates a keyboard problem
Action
1. Look at the keyboard and the keyboard cable for any signs of damage.
2. Press and release each key on the keyboard.