Dell PowerEdge C8000 - Manual (Page 276)

276 Updating Firmware Images and Monitoring the PDU Power Status
Sample output:
3 After the process is completed, the new firmware and fan table versions
display on the screen.
Verifying and Updating the Fan Controller Board
Firmware Via SNMP
NOTE: The following procedure applies only when there are no compute sleds
installed in the server enclosure.
When the PowerEdge C8000 server enclosure is fully populated with five
storage sleds only, you can use Simple Network Management Protocol
(SNMP) to verify and update the fan controller board (FCB) firmware. The
FCB is integrated with an Ethernet connector and supports SNMP v2c that
allows you to monitor the server enclosure status over the network and send
traps or notifications when critical situations occur.
Before You Begin
1 Install a SNMP utility on your computer. You can install a commercial or a
free SNMP utility.
[root@localhost]#./fcbutil_linux64 fcb_fw.bin
FCB Update Utility Ver 0.01.01, 2013/05/24
IPMIVer=02 FWVer=02.20 AuxFW=06000000
FCBVer=02.26 FanTableVer=01.63
Start Copy Image to BMC
100%
Wait: Copy Image to FCB and Update FCB
Done: Update Completed.
Reset BMC!
Wait: BMC Reboot and Connect to FCB
FCBVer=02.27 FanTableVer=01.63
Completed!
[root@localhost]#