Dell PowerEdge C8000 - Manual (Page 191)

Installing System Components 191
Removing a Single-Wide Sled Blank
1 Pull up on the sled blank latch at the bottom of the sled to disengage the
sled from the server enclosure. See Figure 3-3.
2 Using the handle, slide the sled out of the enclosure. See Figure 3-3.
Figure 3-3. Removing and Installing a Single-Wide Sled Blank
Installing a Single-Wide Sled Blank
1 Orient the sled blank so that the release latch is in the bottom of the sled.
See Figure 3-3.
2 Slide the sled blank into the enclosure until the release latch snaps into
place. See Figure 3-3.
1 release latch 2 single-wide sled blank
2
1