Dell PowerEdge C8000 - Manual (Page 160)

160 Using the System Setup Program
Server enclosure
with compute
sleds
• FCB firmware stays in safe
boot mode and waits for
BMC to update firmware.
• FCB firmware detects sled
modules during initialization
only. When you replace a
compute sled, the FCB
controller needs to reset to
detect the new sled.
• The reset to default button
does not work
• FCB firmware disables
network/SNMP service
• FCB firmware update is done
by the BMC
• FCB firmware updates status
to BMC via SC-BMC
protocol
• The firmware update may fail
but not be broken if you
install a compute sled into
the server enclosure while the
FCB firmware update is in
progress
• The reset to default button
does not work
Table 2-21. FCB Firmware Behavior
System
Configuration Safe Boot Code Firmware
Behavior Operational Code Firmware
Behavior