Dell PowerEdge C8000 - Manual (Page 123)

Using the System Setup Program 123
011B SATA Port2 Turns off the 3rd Serial ATA drive controller.
011C SATA Port2 Enables BIOS support for the 3rd Serial ATA drive
controller (enabled if present, POST error appears if
not present).
011D SATA Port3 Turns off the 4th Serial ATA drive controller.
011E SATA Port3 Enables BIOS support for the 4th Serial ATA drive
controller (enabled if present, POST error appears if
not present).
011F SATA Port4 Turns off the 5th Serial ATA drive controller.
0120 SATA Port4 Enables BIOS support for the 5th Serial ATA drive
controller (enabled if present, POST error appears if
not present).
0121 SATA Port5 Turns off the 6th Serial ATA drive controller.
0122 SATA Port5 Enables BIOS support for the 6th Serial ATA drive
controller (enabled if present, POST error appears if
not present).
0135 Embedded SATA
Controller
Disables the SATA controller. This token applies to
the first onboard SATA controller.
0137 Embedded SATA
Controller
Enables the SATA controller to run in IDE mode. Sets
the device class code as IDE and uses PCI IRQ
(referred as Native mode). This token applies to the
first onboard SATA controller.
0138 Embedded SATA
Controller
Enables the SATA controller. Sets the device class
code as SATA and sets up the AHCI BARs and
registers. This token applies to the first onboard SATA
controller.
0139 Embedded SATA
Controller
Enables the SATA controller. Sets the device class
code as RAID and executes the RAID Option ROM.
This token applies to the first onboard SATA
controller.
013E Memory
Remapping
(3GB - 4GB)
When disabled, memory remapping relocates memory
space behind PCI hole to the space above 4 GB.
Table 2-1. D4 Token Table (continued)
Token Setup Option Description