Dell PowerEdge T610 - Manual (Page 99)

Installing System Components
99
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Locate the SD card connector on the internal SD module and, with the
label side facing up, insert the contact-pin end of the card into the slot.
See Figure 3-11.
NOTE:
The slot is keyed to ensure correct insertion of the card.
4 Press the card into the card slot to lock it into place.
5 Close the system. See "Closing the System."
6 Place the system upright and on its feet on a flat, stable surface.
7 Reattach any peripherals, then connect the system to the electrical outlet.
8 Turn on the system and attached peripherals.
Removing an Internal SD Flash Card
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 Locate the SD card slot in the internal SD module and press inward on
the card to release it from the slot and remove the card.
4 Close the system. See "Closing the System."
5 Place the system upright and on its feet on a flat, stable surface.
6 Reattach any peripherals, then connect the system to the electrical outlet.
7 Turn on the system and attached peripherals.
Internal USB Module
Removing the Internal USB Module
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
book.book Page 99 Tuesday, September 15, 2009 10:08 AM