Dell PowerEdge T610 - Manual (Page 80)

80
Installing System Components
Figure 3-2. Removing and Installing the Front Bezel
Opening and Closing the System
WARNING:
Whenever you need to lift the system, get others to assist you. To
avoid injury, do not attempt to lift the system by yourself.
Opening the System
1 Unless you are installing a hot-swap component such as a hard drive or
power supply, turn off the system and attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 Remove the front bezel. See "Removing the Front Bezel."
3 Rotate the system feet inward. See Figure 3-3.
4 Lay the system on its side as shown in Figure 3-3.
1 front bezel 2 lever
3 bezel tab slots (2) 4 bezel tabs (2)
4
2
1 3
book.book Page 80 Tuesday, September 15, 2009 10:08 AM