Dell PowerEdge T610 - Manual (Page 106)

106
Installing System Components
VFlash Media (Optional)
The optional VFlash media is a Secure Digital (SD) card that can be used
with the optional iDRAC6 Enterprise card. See "Integrated Dell Remote
Access Controller 6 (iDRAC6) Enterprise Card (Optional)".
1 Locate the VFlash media slot on the back of the system and insert the
contact-pin end of the SD card (with the label side facing towards the
middle of the system) into the slot. See "Back-Panel Features and
Indicators" for the slot location.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2 Press inward on the card to lock it into the slot.
To remove the card, push inward on the card to release it, and pull the card
from the card slot.
NIC Hardware Key
iSCSI and other functionalities for the system’s embedded NICs are enabled
by installing an optional NIC hardware key in the ISCSI_KEY socket on the
system board.
NOTE:
When future NIC functionality is supported, you must replace the original
NIC hardware key (if installed) with a new hardware key.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Locate the ISCSI_KEY connector on the system board. See Figure 6-1.
4 Insert the NIC hardware key into the connector onto the board. See
Figure 3-14.
book.book Page 106 Tuesday, September 15, 2009 10:08 AM