System battery, Replacing the system battery, See "system battery – Dell PowerEdge T610 User Manual

Page 136

136

Installing System Components

8 Close the system. See "Closing the System."
9 Place the system upright and on its feet on a flat, stable surface.

10 Reattach any peripherals, then connect the system to the electrical outlet.
11 Turn on the system and attached peripherals.
12 Press to enter the System Setup program, and check that the processor

information matches the new system configuration. See "Entering the
System Setup Program."

13 Run the system diagnostics to verify that the new processor operates

correctly.

See "Running the System Diagnostics" for information about running the
diagnostics.

System Battery

Replacing the System Battery

WARNING:

There is a danger of a new battery exploding if it is incorrectly

installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional info.

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet and peripherals.

2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card

Stabilizer."

4 Remove the cooling shroud. See "Removing the Cooling Shroud."
5 Remove the integrated storage controller card. See "Removing an

Integrated Storage Controller Card."

6 Remove the expansion card stabilizer bracket:

Pull the blue release lever, and slide the expansion card stabilizer bracket
up and out of the chassis. See Figure 3-27.

CAUTION:

Do not pull on the control panel cable to unseat the connector. Doing

so can damage the cable.

7 Disconnect the control panel cable from the system board (see