Dell PowerEdge T610 User Manual

Page 52

About Your System

Unsupported

memory

configuration.

DIMM mismatch

across slots

detected:

...

Invalid memory
configuration. Memory
modules are mismatched in
the specified slots.

Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."

Unused memory

detected. DIMM’s

installed in the

following slot

are not available

when in mirror or

128-bit advanced

ECC modes:

The memory configuration is
not optimal for mirroring or
Advanced ECC Memory
Mode. Modules in the
specified slots are unused.

Reconfigure the memory for
Memory Mirroring or
Advanced ECC Memory
Mode, or change the
memory mode to Optimized
in the BIOS setup screen.
See "System Memory."

Warning: A fatal

error has caused

system reset!

Please check the

system event log!

A fatal system error occurred
and caused the system to
reboot.

Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" for any faulty
components specified in the
SEL.

Warning: Control

Panel is not

installed.

The control panel is not
installed or has a faulty cable
connection.

Install the control panel, or
check the cable connections
between the display module,
the control panel board, and
the system board. See
"Control Panel Assembly."

Warning! No micro

code update

loaded for

processor

Micro code update failed.

Update the BIOS firmware.
See "Getting Help."

Table 1-2.

System Messages (continued)

Message

Causes

Corrective Actions

book.book Page 52 Tuesday, September 15, 2009 10:08 AM