Dell PowerEdge T610 - Manual (Page 98)

98
Installing System Components
8 Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
9 Close the system. See "Closing the System."
10 Place the system upright and on its feet on a flat, stable surface.
11 Reattach any peripherals, then connect the system to the electrical outlet.
12 Turn on the system and attached peripherals.
Removing the Internal SD Module
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
4 Remove the cooling shroud. See "Removing the Cooling Shroud."
5 Disconnect the internal SD module cable from the module and from the
system board.
6 Lift upwards on the latch securing the internal SD module to the chassis,
then lift the module out of the chassis. See Figure 3-11.
7 Install the cooling shroud. See "Installing the Cooling Shroud."
8 Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
9 Close the system. See "Closing the System."
10 Place the system upright and on its feet on a flat, stable surface.
11 Reattach any peripherals, then connect the system to the electrical outlet.
12 Turn on the system and attached peripherals.
Internal SD Flash Card
Installing an Internal SD Flash Card
NOTE:
To use an SD card with your system, ensure that the internal SD card port is
enabled in the System Setup program. See "Using the System Setup Program and
UEFI Boot Manager."
book.book Page 98 Tuesday, September 15, 2009 10:08 AM