Dell PowerEdge T610 - Manual (Page 112)

112
Installing System Components
• If you are installing a SCSI tape drive, connect the SCSI interface
cable in the drive kit from the SCSI controller expansion card to the
drive. See "Installing an Expansion Card" to install the SCSI
expansion card.
12 Replace the cooling shroud. See "Installing the Cooling Shroud."
13 Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
14 Close the system. See "Closing the System."
15 Place the system upright and on its feet on a flat, stable surface.
16 Reattach any peripherals, then connect the system to the electrical outlet.
17 Turn on the system and attached peripherals.
18 (Optional) Test the drive by running the system diagnostics. See "Running
the System Diagnostics."
Integrated Storage Controller Card
Your system includes a dedicated slot on the system board for an integrated
storage controller card that provides the storage subsystem for your system’s
internal hard drives. The controller supports SAS and SATA hard drives and
also enables you to set up the hard drives in RAID configurations as
supported by the version of the storage controller included with your system.
Removing an Integrated Storage Controller Card
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
4 Disconnect the data cables from the storage card. See Figure 3-17.
To disconnect a cable, press the blue latches on both sides of the cable
connector and ease it out from the connector on the card.
5 Remove the card from the storage-card slot.
a Pull and hold the blue card guide away from upper corner of the card
to unlock it.
book.book Page 112 Tuesday, September 15, 2009 10:08 AM