beautypg.com

Internal sd module, Installing the internal sd module – Dell PowerEdge T610 User Manual

Page 96

background image

96

Installing System Components

5 Close the system. See "Closing the System."
6 Place the system upright and on its feet on a flat, stable surface.
7 Reattach any peripherals, then connect the system to the electrical outlet.
8 Turn on the system and attached peripherals.

Internal SD Module

Installing the Internal SD Module

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card

Stabilizer."

4 Remove the cooling shroud. See "Removing the Cooling Shroud."
5 Position the module so the tabs on the underside of the tray fit into the

hooks on the chassis, then lower the opposite edge of the card into place.
See Figure 3-11.

book.book Page 96 Tuesday, September 15, 2009 10:08 AM