Acronis Backup for VMware 9 - User Guide User Manual

Page 88

Backing up: Windows Server 2012
Speed: 3.337 MB/s
Schedule: Manual

The Options section on the right shows the settings of the current selected task. This section shows
only the options which differ from default values. If all task options are default, then this section just
states “Options: default” without listing any specific values. Here is an example:

Archive protection: On
Archive encryption algorithm: AES 128
Number of attempts: 10
Interval between attempts: 1 Second(s)
Deduplication: Off
CBT backup: Off
Use FTP in active mode: On
Validate after backup: On

The Source and Target tab in the Source section on the left presents the tree of ESX(i)
hosts+vApps/VMs included into the backup task. The tree is build up dynamically. If there was an
entire ESX(i) host selected for backup, then this tree will be shown for the current state of the
machines (the same list) same as in VMware IC. To the right of the ESX(i) host there should be a mark
that the entire group is being backed up (“All virtual machines” mark). Here is an example:

Resource Pool 1
Windows Server 2012

The Target section on the right presents the information on the location of the backed up archive.
Here is an example:

Location: \\172.20.48.29\Backups\Archives\
Archive: Archive(4)
Retention rules: Type is "Simple Cleanup Scheme'. Delete the backups and archives if backups are
older than 30 day(s). Never delete the last remaining backup.