B&G H5000 Analogue Expansion - Manual (Page 77)

| 77 Autopilot setup | H5000 Operation Manual
Setup
Adjust the display settings, enable the alarm buzzer, change the language, key beeps and
enable advanced mode.
Display
Day mode
Day is the default display mode. The following parameters can be manually adjusted.
• Red backlight
• Inverse display
• Contrast
Night mode
Change the display to night mode color pallet. Lighting adjustments can be made as per the
day mode settings. All displays in the selected lighting zone will also change to night mode.
Lighting group
Set the lighting group on the display. All units in the selected lighting group will mirror each
others light settings. Default setting is Network.
Light level adjustment
Press the MENU key for 3 seconds to access the backlight level screen. The MODE key will
increase the brightness level, the MENU key will decrease the brightness.
¼ Note:
Brightness level (1-10). The light level selection times out after 2 seconds.
Alarm buzzer
Enable / disable the H5000 Pilot Controller alarm buzzer.
Language
Set the desired language
Local
• Reset the H5000 Pilot Controller settings without resetting the autopilot. This will return the
H5000 Pilot Controller to its default sound and light settings
• Advanced settings menu - Enable / Disable
3sec