B&G H5000 Analogue Expansion - Manual (Page 50)

50 | Sensor calibration | H5000 Operation Manual
Setting a calibration value
1 Highlight the value fi eld.
2 Press the MENU key to enable editing of the calibration value. The cursor will fl ash in the value fi eld.
3 Use the UP/DOWN Keys to adjust the value or toggle between plus and minus (+ / -).
4 Press the ENTER key to move to the next number in sequence. The current number will fl ash when
selected.
5 Press the ENTER key when the last digit is highlighted in the calibration fi eld to exit.
6 Select OK.
7 Press ENTER to confi rm and exit. The off set will then be set to the desired value and the
display will return to the calibration page.
¼ Note:
If the calibration off set value fails an error message will appear “Setting off set failed”.
Check sensor connection and source selection and retry.
Boat speed
Speed calibration is necessary to compensate for hull shape and paddlewheel location
on your boat. For accurate speed and log readings, it is essential that the paddlewheel is
calibrated. Boat speed values can be shown in knots, kph or mph. Your preferred unit of
measurement can be set in the units page of the setup menu.