B&G H5000 Analogue Expansion - Manual (Page 26)

26 | Operation | H5000 Operation Manual
Replacing a data page
1 Go to the pages menu.
2 Highlight the page you wish to replace
3 Press MENU
4 Highlight Replace and press the ENTER key
5 Highlight the desired page and press the ENTER key
The new chosen page will be shown in the pages list.
Enabling / Disabling a data page
To make a data page available via the PAGE key you will need to fi rst ensure it has been
selected as one of the eight available pages.
Once the page has been selected as one of the eight data pages you can enable / disable it
1 Highlight the required page via the pages menu
2 Press MENU
3 Highlight Enabled
4 Press the ENTER key to switch the page on or off .
¼ Note:
A tick symbol next to the page denotes that the page is active.
MENU
x2