B&G H5000 Analogue Expansion - Manual (Page 57)

| 57 Sensor calibration | H5000 Operation Manual
Motion correction
When the wind is measured it is initially corrected for masthead unit alignment off set and
mast rotation. Set the mast height and tick Motion Correction for motion correction to be
applied to measured wind speed and wind angle.
¼ Note:
A 3D Motion sensor and mast height value is required in conjunction with a CPU
running Hercules level software or greater to use this feature.
TWA / TWS Correction tables
The TWA and TWS Correction tables receive their information from the H5000 CPU. This
information is not stored in the CPU.
¼ Note:
TWA / TWS correction tables can also be adjusted from the webserver and the Zeus
family MFDs
Editing a correction table
1 Highlight the fi eld that requires editing and press the ENTER key
2 Adjust the correction value to the desired number
3 Select OK once complete to return to the correction table