B&G H5000 Analogue Expansion - Manual (Page 47)

| 47 Operation | H5000 Operation Manual
Mode selection
From Standby mode, press the AUTO key once to enter Auto mode. Whilst in Auto mode a
single press of the MODE key will set the autopilot to Wind mode. Press the MODE key again
to revert to Auto mode.
To access other autopilot modes press and hold the MODE key for 2 seconds. Highlight the
required mode and press the 1º RIGHT key to confi rm.
¼ Note:
The mode selection menu will time out after a few seconds. Whichever mode is
highlighted at this time will be selected.
2 sec
Non Follow Up mode
Whilst in Standby mode, pressing any of the 1º LEFT / RIGHT keys will move the rudder to
your desired angle and change the autopilot mode to Non Follow Up.
Non Follow Up mode allows you to control the rudder position manually via the autopilot
controller.
¼ Note:
The autopliot will remain in Non Follow Up mode until it is disengaged by pressing the
STBY key or a new mode is selected.