B&G H5000 Analogue Expansion - Manual (Page 105)

| 105 Operating variables | H5000 Operation Manual
Time to layline
The information displayed shows the time to go before reaching the appropriate layline.
A value of zero indicates that the layline has been reached. P and S are shown on Graphic
Display to indicate time on each layline. Race Display only shows current layline.
¼ Note: This data is provided by Zeus MFD, normally using arbitrary tacking angles, as such it
should only be considered an approximation.
Variable name (default)
Function name
Time to Layline (tLL)
L/L TIME
Units hh:mm:ss
Alarms N/A
Calibration N/A
Damping N/A
Time to waypoint
Displays time until arrival at the active waypoint at the current speed and course.
Variable name (default)
Function name
Time to Waypoint (t WPT)
TTW
Units hh:mm:ss
Alarms N/A
Calibration N/A
Damping N/A
Trip log
The Trip Log records the distance travelled through the water. The value displayed is the
distance, in nautical miles, travelled from the time the Trip Log was started.
¼ Note:
There are two trip logs
Menu
Variable name (default)
Function name
LOG
Trip Log (TRIP)
TRIP LOG
Units nm
Alarms N/A
Calibration N/A
Damping N/A
Trim (Fore/Aft)
The Trim function displays the fore/aft trim angle of the yacht.
Variable name (default)
Function name
Trim
TRIM
Units Degrees
Alarms N/A
Calibration Off set
Damping 0-9s