Great Plains 3PYP Operator Manual - Manual (Page 46)

42 3PYP Table of Contents Index Great Plains Manufacturing, Inc.
401-312M Table of Contents Index 2014-09-09
Hydraulic System Checklist Page
Check hydraulic reservoir full -
Inspect connections for leaks -
Perform a raise and lower operation 22
Check fan speed and airflow direction
a
a. Operate fan briefly and observe rotor blades
spinning toward exit port. Check rpm on seed
monitor.
If equipped, set CLUTCH Master switch
off, and check hydraulic planter drive
rotation
30
Ensure all FRAME switches are OFF
except Marker Fold
25
Gauge Wheel Planter Drive Checklist Page
Check gauge wheel inflation and tread
condition
125
Set range, transmission and upper drive
sprockets for desired seed rate
47
Check all chains for lubrication and
proper slack
107
Lubricate slider joints on drive shafts 107
Check clutch operation 30
Hydraulic Planter Drive Checklist Page
Check chain lubrication and slack 107
Input initial values for desired seed rate
a
a. Refer to seed monitor manual and Seed Rate
manual.
Pre-run system using seed monitor
Calibration mode to verify hydraulic
action
b
b. Refer to seed monitor manual.
Lubricate slider joints on drive shafts 107
Check clutch operation 30
Meters Checklist Page
Correct meters for seed
a
a. Refer to Seed Rate manual.
Correct wheels for seed *
Correct fingers for seed *
Close clean-out doors 87
Corn?
Check timing of meters for twin-row
*
Check chain tension
Check meter assemblies secured 73
Engage drive couplers 73
Add lubricant to seed if not already done 36