Great Plains 3PYP Operator Manual - Manual (Page 25)

2014-09-09 Table of Contents Index 401-312M
Great Plains Manufacturing, Inc. Table of Contents Index 21
Operating Instructions
This section covers general operating procedures.
Experience, machine familiarity, and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
Pre-Start Checklist
Perform the following steps before transporting the 3PYP
to the field.
High Pressure Fluid Hazard:
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin. Check all hydraulic lines and fittings before
applying pressure. Fluid escaping from a very small hole can
be almost invisible. Use paper or cardboard, not body parts,
and wear heavy gloves to check for suspected leaks. If an
accident occurs, seek immediate medical assistance from a
physician familiar with this type of injury.
❑
Carefully read “Important Safety Information” on
page 1.
❑
Install seed rate meters appropriate for crop. To
change meters, see “Seed Meter Setup and
Adjustment” on page 70.
❑
Install seed wheels appropriate for crop. To change
wheels, see “Singulator Plus™ Meter Wheel
Replacement” on page 72. Make sure correct 6- or
12-finger units are installed for the intended row
spacing.
❑
Lubricate planter as indicated under “Lubrication”
on page 107.
❑
Check all tires for proper inflation. See “Tire
Inflation Chart” on page 125.
❑
Check all bolts, pins, and fasteners. Torque as
shown in “Torque Values Chart” on page 126.
❑
Check planter for worn or damaged parts. Repair or
replace parts before going to the field.
❑
Check hydraulic hoses, fittings, and cylinders for
leaks. Repair or replace before going to the field.