Great Plains 3PYP Operator Manual - Manual (Page 16)

401-312M Table of Contents Index 2014-09-09
12 3PYP Table of Contents Index Great Plains Manufacturing, Inc.
Preparation and Setup
This section helps you prepare your tractor and 3PYP for
use, and covers tasks that need to be done only once per
hitch, seasonally, or when the tractor/planter
configuration changes.
Before using the 3PYP in the field, you must hitch the
planter to a suitable tractor, inspect systems, level the
planter. Before using the planter for the first time, and
periodically thereafter, certain adjustments and
calibrations are required.
Initial Setup
Prior to first use, and if the tractor changes, these items
need to be completed:
• Install tractor cab consoles (page 148).
• Set initial down-pressure (option, page 155).
• Check center section and wing level (page 157).
• Install Options not factory- or dealer-installed.
Pre-Setup Checklist
1. Read and understand “Important Safety
Information” on page 1.
2. Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.
3. Check that all grease fittings are in place and
lubricated. Refer to “Lubrication” on page 107.
4. Check that all safety decals and reflectors are
correctly located and legible. Replace if damaged.
See “Safety Decals” on page 5.
5. Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “Tire Inflation Chart”
on page 125.