Tweco VAF4 Transmig - Manual (Page 30)

TRANSMIG VAF4
INSTALLATION, OPERATION AND SETUP 3-12 Manual 0-5231
Advanced Feature Left Display
Feature Description
Right Display
Parameter / Selection
Wirefeed Speed Units
This allows setting of the Wirefeed
Speed Meter to display in IPM or
MPM units.
Default Wirefeed Speed = MPM
IPM (inches per
minute)
MPM (metres per
minute)
Arc Hours Accumulated Run Time
A Read Only display of the total of
actual arc hours.
0.0 – 999.9 hours
(It will rollover to 0
once 999.9 hours
have been reached.)
Left Display Type
This allows the user to select what
is shown on the LEFT Display when
welding.
With some power sources, it may
not be possible to display welding
amps on the VAF4 display when
welding, in this case, set the display
to wirefeed speed (WFS) or Blank
(BLNK)
Default Left Display = AMPS
Display AMPS when
welding or
Display WIREFEED
SPEED when
welding or
Display BLANK
when welding
Right Display Type
This allows the user to select what is
shown on the RIGHT Display when
welding.
With some power sources, it may
not be possible to display welding
volts on the VAF4 display when
welding, in this case, set the display
to Blank (BLNK)
Default Left Display = VARC
Display ARC VOLTS
when welding or
Display BLANK
when welding