Tweco HMC-410 - Manual (Page 74)

HMC-410
6-2 July 27, 2005
6.04 Control Cables:
These control cables are used from the HMC-410 to the
power source, and for the HMC-410 to the feedhead, thus
2 are required per system.
Description Part Number
2’ Control Cable 170552-005
10’ Control Cable 170552-001
15’ Control Cable 170552-006
25’ Control Cable 170552-002
50’ Control Cable 170552-003
75’ Control Cable 170552-007
100’ Control Cable 170552-004
6.05 171238-17 Software Kits
The 171238-17 Software Kit has the following additional features:
Feature Benefit
1. Programmable Gun Switch A. Allows user to customize gun switch speed for changing weld levels
Sensitivity (SP) at gun with a flick of the switch.
2. Password Protection (UPS, A. Allows the supervisor to protect weld settings.
SPS)
B. Eliminate uncontrolled access to importanct weld parameters.
3. Arc Monitoring (IL, IP) A. Allows customer to perform some basic weld monitoring.
B. Verify that basic weld currents occur for some set amount of time.
4. Trim Adjustment Range A. Allows customer to limit amount of change by operators from some
(ADJ) preset level
B. Allows operator ability to tweak in operating point while reducing the
possibility of operating out of the process range
5. Remote Schedule Selection A. Ability to select 1 of 8 schedules remotely while welding or in standby
(RSE)
6. Display Filter (DF)
A. Ability to make display read update at an optimum rate for each
application
Table 6-1: Software Kits 171238-17
See the descriptions of the softswitches for details on these and other additions to the HMC-410 capability.