SoundOff Signal Magnum LED - Manual (Page 6)

IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to [email protected].
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
1. Locate the permanent hardware kit that is included.
2. Slide 5/16 carriage bolts into extrusion t-slots. Place mounting foot
onto slots and tighten foot with washer and nut, ensuring the use of
either a lock washer or lock nut.
3. Temporarily place lightbar in its correct position on the roof of the
vehicle. The bar should be positioned about the center of the vehicle B
pillar. Determine the appropriate position of the mounting feet brack-
ets on the lightbar to the vehicle roof and reposition mounting feet as
needed.
4. Remove the rubber feet.
5. Measure and/or mark the 2 holes in roof to match mounting feet lo-
cations. See warning messages below. Drill holes for ¼" bolts (F drill).
6. Install hardware as shown in image to the left.
7. Route cables into vehicle. Use supplied rubber grommet in roof for
sealing/ protection of wires. It is recommended that silicone be placed
around grommet to ensure roof sealing.
FIXED HEIGHT BRACKETS
PERMANENT MOUNTING
!
WARNING
Route wires only in locations that are not subjected to
potential wear. Make sure to avoid routing wires in the
deployment area of your air bag. Refer to your vehicle’s
owner’s manual for airbag deployment zone.
!
WARNING
Care must be taken when drilling through the roof of the
vehicle not to drill into any existing wiring and not to drill
through the headliner or support members of the vehicle.
Check both sides of the mounting service prior to drilling.
De-burr any holes and remove any metal shards or remnants.
Install grommets into all wire passage holes.
#EMG2000 MAGNUM™ LED Lightbar
Extra Low & Permanent Mounting Foot
2x 1/4"-20 x 1"
Hex Head Screw
2x 1/4" Lock
Washers
2x 1/4" Flat
Washers
2x 1/4"-20
Square Nuts
T-Slots for adjustability
for correct roof fit
T-Slot Gasket location
Remove Rubber Feet 2x