SoundOff Signal Magnum LED - Manual (Page 12)

IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to [email protected].
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
NORMAL OPERATION
Under normal operation with lightbar turned on the breakout box will have the Green and Red LED light on steady. When you change an input to the lightbar the Red
LED on the breakout box will flash then go back to steady.
When the lightbar is off (no input active) the Green LED on the breakout box will stay on for 15 seconds then go off putting the lightbar into sleep (standby) mode. The
Red LED will flash every 5 seconds to tell you there is power to the breakout box and it is waiting for an input to turn on the lightbar.
NO OPERATION
No LED on or flashing on Breakout box; Check input power and ground to lightbar, check data cable for damage and/ or opens, check FH4 (5A) fuse on the
electronic control board in lightbar.
Breakout box LED's operating correctly; Check FH1 (20A) & FH2 (20A) fuse on the electronic control board in lightbar
(see above)
NO OR INCORRECT INBOARDS OR CORNER LIGHTS (WARNING)
Breakout box LED's operating correctly; Check FH1 fuse on the electronic control board in lightbar
No steady Red LED on breakout box; Check 24-pin connector at breakout box (insure it is snapped in correctly), check appropriate input to breakout
box for output lights which should be on
No rear warning lights; Check dip switch SW5 setting for full (off) or split (on) arrow (on full you may not get any warning) (after arrow
dip switch changes main power must be cycled)
NO TAKE DOWNS OR ALLEY LIGHTS
Breakout box LED's operating correctly; Check FH2 (20A) fuse on the electronic control board in lightbar
No steady Red LED on breakout box; Check 24-pin connector at breakout box (insure it is snapped in correctly), check appropiate input to breakout
box for output lights which should be on
INCORRECT OR NO ARROW OPERATION
Breakout box LED's operating correctly; Check dip switches setting on the electronic control board in lightbar (after arrow dip switch changes main
power must be cycled)
No steady Red LED on breakout box; Check 24-pin connector at breakout box (insure it is snapped in correctly), check appropiate input to breakout
box for output lights which should be on
Arrow direction incorrect; Change passenger/ driver side dip switch SW4 on the electronic control board in lightbar (after arrow dip switch
changes main power must be cycled)
8-wire control not operating; Check dip switch setting SW1-3 (should be off, off, off) on the electronic control board in lightbar (after arrow dip
switch changes main power must be cycled)
Split arrow not operating; Check dip switch SW5 (should be on) on the electronic control board in lightbar (after arrow dip switch changes
main power must be cycled)
MAGNUM TROUBLESHOOTING
#EMG2000 MAGNUM™ LED Lightbar