Banner PresencePLUS Pro—PRO Camera - Manual (Page 20)

01/04
Controller Terminal Block PresencePLUS ® Pro
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
14
P/N 68368 rev. B 01/04
Supply Voltage, Pins 1 and 2
The controller requires a 10 to 30V dc power supply with a maximum current of 1.5 amps.
NOTE: When connecting a light source to the controller, verify that the voltage used is compatible with the voltage
requirements of the light source.
• Connect pin 1 to +V
• Connect pin 2 to –V
Trigger, Pin 3
• Input from an external triggering device is needed to signal the camera to acquire images.
• The system can be set to respond to either the leading or trailing edge of the trigger pulse.
• Trigger pulse width can be set from 1 ms to 10 seconds. The default is 1 ms.
• Trigger modes:
- Input current sinking mode (external PNP driver)
- Input current sourcing mode (external NPN driver)
-------------------------------------
PNP and NPN Leading-Edge and Trailing-Edge Trigger Inputs
------------------------------------------------------------------
Input Trigger Signal
Inspection
Idle
OFF
ON
ON
OFF
Inspection
Idle
Inspection
Idle
OFF
ON
ON
OFF
Inspection
Idle
Minimum Pulse Width
1-10,000 ms
Minimum Pulse Width
1-10,000 ms
Minimum Pulse Width
1-10,000 ms
Minimum Pulse Width
1-10,000 ms
Input Trigger Signal
Input Trigger Signal Input Trigger Signal
Trigger Delay Trigger Delay
Trigger Delay
Trigger Delay
Leading-Edge PNP Configuration Trailing-Edge PNP Configuration
Leading-Edge NPN Configuration Trailing-Edge NPN Configuration