Metrohm 793 IC Sample Preparation Module - Manual (Page 31)

3.3 Operation via 732 IC Detector
793 IC Sample Prep Module/ 8.793.1003 Instructions for Use
27
Rotate SP Module A at an event
In the 732 IC Detector the key can be used to
program a maximum of 4 different events (see section 4.7.3 of
732/733 Manual ). At each event the SP Module A can be brought
into the next position by setting remote output lead 2 to 1 (on,
active, 0 V). This lead must later be returned to the setting 0 (off,
inactive, open) before the SP Module A can be switched to the
next position.
Rotate:
EVENT YY-MM-DD HH:MM:SS
remote
✴ 1 ✴✴✴✴✴✴
Reset
output lead:
EVENT YY-MM-DD HH:MM:SS
remote
✴ 0 ✴✴✴✴✴✴
SP Module A position display
STEP
ACTUATOR The position display 7 777 of the 793 IC Sample Prep Module beside
switch 8 888 shows whether the SP Module A is in the right position:
Lamp on SP Module A in the right position
Lamp off SP Module A in the wrong position or blocked
(procedure see section 4.1)