Metrohm 793 IC Sample Preparation Module - Manual (Page 13)

2.2 Mains connection
793 IC Sample Prep Module/ 8.793.1003 Instructions for Use
9
13 13 13 13
220 ---- 240 V
100 ---- 120 V
19 19 19 19
20 20 20 20
220 ---- 240 V
100 ---- 120 V
Fig. 4: Setting the mains voltage
2.2.2 Fuses
One of the two fuses 0.5 A/slow-blow for 100}120 V or 0.25 A/slow-
blow for 220}240 V is installed in fuse holder 20 20 20 20 of the 793 IC Sample
Prep Module as standard.
Ensure that the instrument is never put into operation with fuses of
another type, otherwise there is danger of fire!
For checking or changing fuses, proceed as described in section 2.2.1.
2.2.3 Mains cable and mains connection
Mains cable
The instrument is supplied with one of three mains cables:
x 6.2122.020 with plug SEV 12 (Switzerland, })
x 6.2122.040 with plug CEE(7), VII (Germany, })
x 6.2133.070 with plug NEMA 5-15 (USA, })
which are three-cored and fitted with a plug with an earthing pin. If a dif-
ferent plug has to be fitted, the yellow/green lead (IEC standard) must
be connected to protective earth (protection class I).
Any break in the earthing inside or outside the instrument can make it
a hazard!
Mains connection
Plug the mains cable into mains connection plug 19 19 19 19 of the 793 IC
Sample Prep Module (see Fig. 4).
2.2.4 Switching the instrument on/off
The 793 IC Sample Prep Module is switched on and off using mains
switch 13 13 13 13. When the instrument is switched on lamp 1111 lights up.
100 – 120 V 220 – 240 V
13 13 13 13 Mains switch
19 19 19 19 Mains connec-
tion plug
22220000 Fuse holder