ClearCube PCoIP System User's Guide - Manual (Page 96)

6.8 Managing Sessions (Connections) and Device Behavior
ClearCube Technology, Inc. 89
NOTE: You can use the Session Control Web interface page to connect and disconnect devices
using standard static sessions only.
Figure 42. Detail from the Session Control Web interface page
To access the Session Control page, display the zero client or host card Web interface as
described in
6.3 “ Using the Web Interface
” on page
63 . Connect or disconnect the devices as
described below.
The following list describes the information and items on the page.

Connection State
As shown in the previous figure, the Connection State field displays the current state of the
session. Values are:

Disconnected

Connection Pending

Connected

Connect
If the connection state is Disconnected , click Connect to start a PCoIP session between a
zero client and its peer device, or host. If the connection state is Connection Pending or
Connected , the Connect button is disabled.
After you click the Connect button, it is disabled. You must refresh the page to use it again.