ClearCube PCoIP System User's Guide - Manual (Page 90)

6.6 Connecting to a Device
ClearCube Technology, Inc. 83
The following figure shows the architecture described in this section.
Figure 38. Unmanaged DHCP with SLP discovery
When connecting a blade and a zero client on a network with a DHCP server, you can enable
both devices to accept a dynamic IP addresses.
NOTE: Ensure that your chassis and zero client are connected to a switch on a network with a
DHCP server.
1. Ensure that you have set up devices as described in 4.2 “ Mandatory Mounting, Cooling, and
Airflow Provisions ” on page 34 and in 4.4 “ Mandatory Network-Related Settings ” on page 39 .
2. Connect the chassis to a network switch.
a. Connect one end of a CAT5 or CAT6 Ethernet cable to the appropriate port on your chassis.
 R4300 chassis—insert the cable in the Secondary Network port.
 A3100 chassis—insert the cable in the PCoIP port.
b. Connect the other end of the cable to a network switch on a known subnet.
3. Connect the zero client to a network switch.
a. Connect one end of a CAT5 or CAT6 Ethernet cable to the RJ-45 connector on the
zero client.