ClearCube PCoIP System User's Guide - Manual (Page 55)

Chapter 4. Initial Setup
48 PCoIP System User’s Guide
6. Use an Ethernet cable to connect the zero client to a network switch on the same subnet as the
host card (that is, the subnet that the blade is on).
7. Connect monitors, a mouse, and a keyboard to the zero client.
8. Connect the zero client power adapter to the zero client and then plug the cord into a
power outlet.
Continue by configuring the zero client as shown below.
Configure the Zero Client
1. Press the zero client’s power button to power it on.
2. From the monitors connected to the zero client, click the Connect button. After several
moments, the zero client will discover and identify the host cards to which it can connect by
showing each host card’s IP address and MAC address.
3. Find the host card you are connecting to and record the IP address (the video host card MAC
addresses is specified on a label on the side of the blade).
4. Click the Cancel button to return to the zero client OSD (on screen display).
5. From the OSD menu on the upper-left portion of the screen, click Options > Configuration.
6. Click Unlock (located on the lower-left portion of the screen) and then click OK (the
password is blank empty by default).
7. Click the Session tab. From the Connection Type drop-down menu, select Direct to Host.
8. Enter the host card’s IP address that you recorded previously.
9. Click Apply in the lower-right portion of the screen, and then click OK. You are returned to
the OSD screen.
You can now connect to the host card as described below.
Connect to the Host Card
1. From the OSD, click Connect. After several moments, the zero client connects to the blade’s
host card and displays the OS login screen or desktop.
2. Press the zero client power button twice to select the Power Off Workstation option on the
zero client pop-up menu. The zero client power button should be green and begin to flash.