ClearCube PCoIP System User's Guide - Manual (Page 74)

6.4 Configuring Blades
ClearCube Technology, Inc. 67
Figure 31. OSD interface
6.4
Configuring Blades
The following sections describe blade configuration options.
6.4.1 Blade Video Settings
See “ 6.4.1 Blade Video Settings
” on page
67 for instructions about video configuration.
6.4.2 Enabling Audio on a 64-bit OS
NOTE: The 64-bit audio setting shown below only applies to PCoIP using Teradici firmware
version 4.2.0 and lower.
If you are using a 64-bit operating system on a host, ensure that 64-bit audio is enabled in the host
card’s Web interface. This option is on by default. If the 64-bit audio option is off, you might
experience poor audio or no audio output from your host.
1. Enter the host card’s IP address in a Web browser. See 6.1 “ Finding a Device’s IP Address
and MAC Address
” on page
56 for information about finding a device’s IP address.