ClearCube PCoIP System User's Guide - Manual (Page 81)

Chapter 6. Configuring Devices, Setting Peers, and Connecting
74 PCoIP System User’s Guide
f. From the Session tab, select IP address in the Identify Peer by line. Specify the
following in the appropriate fields:
 Identify Peer by—The host card IP address
 Peer MAC Address—The host card MAC addresses (printed on a label on the side
of the blade)
g. Click Apply and then click OK to close the Configuration page. You can now continue
to provision the host card on the blade.
5. Provision the host card on the blade.
a. Open a Web browser on a computer with a static IP address on the same subnet as the
host card you are provisioning.
b. In your browser, type the IP address of the host card to open the host’s Web interface.
c. From the Log In page, click Log In (you should not have to type a password).
d. From the Network page, ensure that the Enable DHCP option is cleared. Specify the
following values for the host card:
 IP Address
 Subnet Mask
 Gateway
e. Click Apply and then click Continue.
f. Click Configuration > Session. Perform either one of the following steps:
 To ensure that a host can only connect to a specific zero client, leave the Accept Any
Peer option clear. In the Peer IP Address line and the Peer MAC Address line,
type the appropriate addresses of the zero client (the MAC address is on a label on
the bottom of the zero client).
—OR—
 To enable administrators to move zero clients from one host to another without
modifying the host’s peer data, leave the Accept Any Peer option selected.
g. Click Apply and then click Continue.