ClearCube PCoIP System User's Guide - Manual (Page 77)

Chapter 6. Configuring Devices, Setting Peers, and Connecting
70 PCoIP System User’s Guide
Figure 32. Session page
4. Verify that the devices are peers.
To verify that devices are set as peers, click Connect from the OSD and select the host to
which to connect. Perform either one of the following steps:

Click Configuration > Session and verify the address shown as the Peer IP Address.
—OR—

Click Diagnostics > Session Control and verify the Peer IP Address is the peer you
specified in the previous step. If the address is not correct, specify the correct address. A
device does not have to be connected to display its peer.