ClearCube PCoIP System User's Guide - Manual (Page 114)

9.5 Troubleshooting Firmware Updates
ClearCube Technology, Inc. 107
You can now continue to verify your firmware installation as described in 9.2 “ Identify Firmware
on Device You Are Updating
” on page
105 .
9.4.2 Host Card
1. Click Reset to reset the PCoIP processor, and then click OK. After several moments the
device displays the message: The PCoIP processor will reset on the next
host system restart; your changes will take effect then. Are
you s ure you want to proceed?
2. Click OK to continue. If a session is active, you can reset the remote blade (the host system)
by pressing the remote power button on the zero client.
If a session is not active, you can remove the blade from the chassis and then re-insert it to
reset the system.
You can now continue to verify your firmware installation as described in 9.2 “ Identify Firmware
on Device You Are Updating
” on page
105 .
9.5
Troubleshooting Firmware Updates
If upgrading firmware does not seem to have any effect:

Verify the integrity of the .zip file using your file compression tool of choice.

Be sure to reset the device before verifying the update