3 setting msl on a-series blades, Setting msl on a-series blades – ClearCube PCoIP System User's Guide User Manual
Page 105
Chapter 8. Mass Storage Lockout (MSL)
98
PCoIP System User’s Guide
Figure 44. JP6 MSL header in default position on R3080D motherboard
3. Use needle-nose pliers to move the jumper. Perform one of the following steps:
To enable MSL
Move the JP6 jumper to pins 1 and 2. This setting prevents access to USB devices
connected to the blade or to the zero client.
—OR—
To disable MSL
Move the JP6 jumper to pins 2 and 3. This setting enables access to USB devices
connected to the blade or to the zero client.
4. Return the blade to a chassis and power on the blade.
Depending on the MSL option you set, access to USB devices connected to the blade or to the
client is enabled or disabled.
8.3
Setting MSL on A-Series Blades
MSL is disabled by default. MSL is set differently depending on A-series model.