ClearCube PCoIP System User's Guide - Manual (Page 49)

Chapter 4. Initial Setup
42 PCoIP System User’s Guide
The list below shows operating systems that Teradici Host Driver Software supports.

Windows 8.1, 64-bit

Windows 7, 32- and 64-bit

Windows Vista, 32- and 64-bit

Windows XP SP2, 32- and 64-bit

Windows Server 2008, Server 2008 R2

Windows Server 2003 (not supported by V5140 host cards)

Linux ® is supported but has not been tested. Ensure that the Linux distribution you use
contains drivers that support:

Open Host Controller Interface (OHCI) and Enhanced Host Controller Interface (EHCI)
for USB

Realtek HD audio

GPU drivers if applicable (note that V52x0- and V53x0-series host cards include GPUs
and require GPU drivers).
See the following section for information about requirements when creating your own operating
system images.
4.5
Image Creation Requirements
By default, ClearCube zero clients, host cards, and blades using PCoIP technology contain all
necessary firmware and drivers, and blade operating system images are configured appropriately.
If you are re-imaging a blade or installing a custom image on a ClearCube blade, note that your
blade and devices using PCoIP technology require specific firmware, motherboard chipset
drivers, device drivers, and more.
NOTE: ClearCube devices do not necessarily support every driver for firmware that vendors
provide. To ensure that your devices support drivers and firmware, only use drivers and
PCoIP firmware obtained from ClearCube.