ClearCube PCoIP System User's Guide - Manual (Page 91)

Chapter 6. Configuring Devices, Setting Peers, and Connecting
84 PCoIP System User’s Guide
b. Connect the other end of the cable to a network switch on the same subnet as the chassis.
This switch can be the same switch used in step the previous step.
5. Configure networked devices as described in 3.8 “ Port and Protocol Requirements
” on page
31 and 4.4 “ Mandatory Network-Related Settings
” on page
39 .
4. Configure the zero client.
a. Briefly press and hold the power button on the front of the zero client to start it.
b. Click Options > Configuration to open the Configuration window. From the Network
tab, select the Enable DHCP option. Click Apply and then click OK.
c. From the Discovery tab, select the Enable Discovery and Enable Host Discovery
options. Click Apply and then click OK.
NOTE: Using SLP discovery, the Connect screen (OSD) displays a maximum of 10
hosts (blades). Remember that there might be more PCoIP hosts on your
network that are not displayed.
Your zero client is now configured to discover blades automatically.
6. Provision the host card on the blade.
a. Open the host card’s Web interface (see page 56 for instructions about finding an IP
address, and see page 63 for information about opening a Web interface).
b. From the Web interface, click Configuration > Monitor Emulation. Select the monitor
emulation option for both monitors (DVI 1 and DVI 2).
c. Click Apply and then click Continue.
d. Click Configuration > Discovery and select the Enable SLP Discovery option.
e. Click Apply to save your changes and a success message is displayed. Click Reset and
then click OK to reset your blade and apply your changes.
f. Close the browser.
7. Return to the zero client and click Connect to display the Discovered Hosts dialog box.
8. Click OK to connect your configured zero client and blade.