Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 20)

3-2 DeviceNet Adapter for use with DPI AC Drives
Step 2. Set the data rate switch as shown in figure 3.2
Setting Description
0-63 Node address used by the adapter if switches are
enabled. The default switch setting is 63. Node
address 63 is also the default address used by all
uncommissioned devices. Do not use this address
as the final adapter address.
Important: If the Data Rate switch is set to “PGM”
(Program), the adapter will use the setting of DN
Addr Cfg (3) for the node address. The default
parameter setting is 63. Refer to chapter 4,
Configuring the DeviceNet Adapter.
64-99 Do not use. The adapter does not recognize these
addresses.
Figure 3.1 – Setting the Node Address
2
1
0
9
8
3
4
5
6
7
2
1
0
9
8
3
4
5
6
7
Tens
Digit
Ones
Digit
Setting Description
Auto The adapter is set to the data rate used by other
network devices. Another device on the network
must be set to a data rate.
125 K
250 K
500 K The adapter is set to the respective data rate.
PGM The adapter uses the setting of DN Rate Cfg (5) for
the data rate. Refer to chapter 4, Configuring the
DeviceNet Adapter.
Figure 3.2 – Setting the Data Rate
125K
250K
500K PGM
AUTO