Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 100)

B-8 DeviceNet Adapter for use with DPI AC Drives
Sets the data that is sent to the Datalink in the drive if any of the
following is true:
• Idle Flt Action (11) is set to Send Flt Cfg and the scanner is put
into Program mode.
• Comm Flt Action (10) is set to Send Flt Cfg and communications
are disrupted.
• Peer Flt Action (34) is set to Fault Cfg and communications are
disrupted.
Master-slave input data. This data is produced by the scanner and
consumed by the adapter.
17
18
19
20
21
22
23
24 Flt Cfg A1
Flt Cfg A2
Flt Cfg B1
Flt Cfg B2
Flt Cfg C1
Flt Cfg C2
Flt Cfg D1
Flt Cfg D2
Range: 0 to 4294967295
Default: 0
Type: Read/Write
Reset Required: No
25 M-S Input
Range: 0 = I/O Disabled
1 = I/O Enabled
Default: See figure B.3.
Type: Read/Write
Reset Required: Yes
Figure B.3 – M-S Input (25)
0 0 0 1 0 x x x
0 1 2 3 4 5 6 7
1 =I/O Enabled
0 =I/O Disabled
x =Not Used
Cmd/Ref DL A Input DL B Input DL C Input DL D Input Not Used Not Used Not Used