Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 16)

2-2 DeviceNet Adapter for use with DPI AC Drives
2.2 Required Equipment
Table 2.2 lists the equipment shipped with the DeviceNet adapter.
When you unpack the adapter, verify that the package includes all
of these items.
Table 2.3 lists user-supplied equipment also required to install and
configure the DeviceNet adapter.
Table 2.2 – Equipment Shipped with the DeviceNet Adapter
Item Description
DeviceNet adapter
2.54 cm (1 in) and 15.24 cm (6 in) Internal Interface cables
(Only one cable is needed to connect the adapter to the drive)
Five-pin linear DeviceNet plug (connected to the DeviceNet
connector on the adapter)
Grounding wrist strap
DeviceNet Adapter User Manual (D23478)
Table 2.3 – Required User-Supplied Equipment
Item Description
A small flathead screwdriver
DeviceNet cable
• Thin cable with an outside diameter of 6.9 mm (0.27 in.) is
recommended
Configuration tool, such as:
• LCD OIM
• VS Utilities
• RSNetWorx for DeviceNet
• Serial Converter
Computer with a DeviceNet communications adapter installed
(such as 1784-PCD, 1784-PCID, 1784-PCIDS, or 177-KFD)
Controller configuration software (examples: RSLogix5,
RSLogix500, or RSLogix 5000)