Rockwell Automation 1440-TPS02-01RB XM-320 Position Module - Manual (Page 51)

Publication GMSI10-UM005C-EN-P - May 2010
Installing the XM-320 Position Module 43
Basic Operations Powering Up the Module
The XM-320 performs a self-test at power-up. The self-test includes an LED
test and a device test. During the LED test, the indicators will be turned on
independently and in sequence for approximately 0.25 seconds.
The device test occurs after the LED test. The Module Status (MS) indicator is
used to indicate the status of the device self-test.
Refer to Module Indicators on page 41 for more information about the LED
indicators.
Manually Resetting Relays
The XM-320 has an external reset switch located on top of the module, as
shown in Figure 2.27.
Figure 2.27 Reset Switch
MS Indicator State Description
Flashing Red and Green Device self test is in progress.
Solid Green or Flashing Green Device self test completed successfully, and the
firmware is valid and running.
Flashing Red Device self test completed, the hardware is OK, but the
firmware is invalid. Or, the firmware download is in
progress.
Solid Red Unrecoverable fault, hardware failure, or Boot Loader
program may be corrupted.
POSITION
1440-TPS02-01RB
Press the Reset
Switch to reset the
relays