Rockwell Automation 1769-L24ER-QB1B_L24ER-QBFC1B_L27ERM-QBFC1B CompactLogix 5370 L2 Controllers Quick Start - Manual (Page 29)

Rockwell Automation Publication IASIMP-QS025B-EN-P - December 2012 29
Prepare the CompactLogix 5370 L2 Controller Hardware Chapter 1
Make a DeviceNet Network Connection
1. Attach and lock the
1606-XLDNET8 DeviceNet power
supply to the DIN rail.
The power supply uses a locking tab
at the top that you push down to
secure it to the DIN rail.
2. Assemble the DeviceNet network
cable system using the KwikLink flat
cable, terminators, and sealed micro
connectors for each device.
For more information on how to
assemble the DeviceNet network
system, see the instructions included
with these devices.
3. Wire a KwikLink QD Micro
Cordset to the 1769-SDN
connector.
4. Plug the 1769-SDN connector into the 1769-SDN scanner module.
5. Connect the other end of the KwikLink QD Micro Cordset to a KwikLink sealed micro
connector on the network.
Connect To
Red V+
White CAN High
Bare Shield
Blue CAN Low
Black V-
Input
AC 100-120/200-240V
N L
Isolat e power bef ore disc onnec ting
1606-XL
POWER SUPPL
Y
DC ok
Output
200W Limit ed Powe r DC 24V / 8A
+ –
DC ok
AC 120V
AC 240V
Input
AC 100-12
0/200-24 0V N L
Isolate p ower befo re disc onnectin g
1606-X
L POWER SUPPL
Y
DC ok
Output
200W L imited P ower DC 24V / 8A
+ –
DC o k
AC 120V
AC 240V
To other device on
network
To other device on
network
1606-XLDNET8
DeviceNet Power Supply
KwikLink Sealed
Terminator
KwikLink Sealed
Terminator
KwikLink Sealed
Micro Connector