Rockwell Automation 2706-LV2P_LV2R_LV4P_LV4R DL40 PLUS USER MANUAL - Manual (Page 39)

Using the Onboard Editor to Create Messages 2–13
Publication 2706-6.1
Energize Relay
Activating this attribute displays the message and energizes the
display’s alarm relay whenever the message is triggered.
The alarm relay will not de-energize even after the Wait Time has
expired. The relay will de-energize when:
•
a message is run for which the Energize relay attribute is not
activated
•
any Special Message runs
•
the display exits Run mode
Important: AutoClear de-energizes the alarm relay only if the
cleared message has the Energize relay enabled.
!
ATTENTION: Use the relay for annunciator purposes
only. Do not use it for control.
Type [Y][
↵
] to activate or [N][
↵
] to deactivate.
Stack Message
This attribute records the message number and trigger time of the
message on the Historical Events Stack. Variables are also placed on
the stack. Stacked messages can also be stamped with the time the
message was run (as opposed to the trigger time stamp).
If AutoRepeat is enabled, the message number (and time) is put on
the Historical Events Stack only once each time the message is
triggered and/or run rather than each time it repeats.
The message
number, variables, and time (if applicable) are put on the Historical
Events Stack while the message is running or repeating only when
updates to variables are received by the DL40 Plus.
Type [Y][
↵
] to activate or [N][
↵
] to deactivate.
Stack Time
This attribute records the time and date the message was run on the
Historical Events Stack. By default, only the time and date when the
message was triggered is recorded.
Type [Y][
↵
] to activate or [N][
↵
] to deactivate.